Function Menu Item List - Sony MSW-A2000 Operation Manual

8-2 Function Menu Item List

The function menu has the following items.
HOME page
Item
Setting
F1 (VID.IN) Selects the input video signal.
COMPST: Analog composite signal
Y-R,B: Analog component signal
SDI: SDI signal
SDTI: SDTI-CP signal
SG (normally not displayed): Test signal from the internal test signal generator (For details, see setup
menu item 710 on page 8-19.)
F2 (PB/EE) Selects the video and audio signals output during fast forward, rewind, stop, and standby.
PB: Playback signals
EE: E-E mode signals
F3 (CONFI) Selects whether or not to use the CONFI playback function when recording.
ENABLE: Use the CONFI playback function.
DISABL: Do not use the CONFI playback function.
F4 (CTL/TC) Selects the time data to display in time data display area 1 (see page 2-7) .
TC: Playback time code read by the internal time code reader, or recording time code. The LTC or VITC
time data type indicator (see page 2-7) lights.
UB: User bits data of playback time code or recording time code. The LUB or VIUB time data type indicator
lights, depending on whether the time code is LTC or VITC.
CTL: The running time of the tape being played back or recorded, as calculated from a count of CTL
signals recorded on the tape. The time is displayed in Hours:Minutes:Seconds:Frames format.
F5 (MENU) Puts the system into setup menu mode (see Chapter 8) .
When the current setup menu settings are the same as the contents of any of menu banks 1 to 3, or the
factory defaults, the corresponding indication (1), (2), (3), or (dflt) appears.
(1): Same as menu bank 1.
(2): Same as menu bank 2.
(3): Same as menu bank 3.
(dflt): Same as factory defaults.
F6 (TCGSET)
• When F4 (CTL/TC) is set to TC, a screen appears that allows you to set the initial value of the time code
generated by the internal time code generator (see page 4-3) .
• When F4 (CTL/TC) is set to UB, a screen appears that allows you to set the time code user bits (see
page 4-3) .
a) When an editing operation is carried out, CONFI playback is disabled.
b) The selection of LTC or VITC depends on the setting of F6 (TCR) in function menu page 1 .
a)
b)
b)
Chapter 8 Function Menu
8-3