Sony MSW-A2000 Operation Manual page 114

9-4 Items in the Extended Setup Menu
Item number Item name
301 VAR SPEED RANGE FOR
SYNCHRONIZATION
302 CAPSTAN RE-LOCKING
DIRECTION
304 EDIT FIELD SELECT
305 SYNC GRADE
306 DMC INITIAL SPEED
307 AUTO-DELETION FOR
INCONSISTENT DATA
9-12
Chapter 9 Setup Menus
Menu items in the range 300 to 399, relating to editing operations
Settings
Select the playback speed range when carrying out playback in variable speed
mode from a remote control unit connected to the REMOTE-1 IN(9P) connector
or REMOTE-1 OUT (9P) connector.
–1~+3 : For MPEG IMX tapes, analog tapes, and Digital Betacam tapes, from –1
to +3 times normal speed; for Betacam SX tapes, –1 to +2 times normal
speed.
~+3.45 : For MPEG IMX tapes, analog tapes, and Digital Betacam tapes, from
–1 to +3.45 times normal speed; for Betacam SX tapes, –1.5 to +2.3 times
normal speed.
WIDE: Undefined
In 525-line mode
When the function menu item CAPSTN is set to 4F, select whether the capstan
servo should lock by accelerating or decelerating.
DECEL : Lock by decelerating.
ACCEL: Lock by accelerating.
In 625-line mode
When the function menu item CAPSTN is set to 4F or 8F, select whether the
capstan servo should lock by accelerating or decelerating.
DECEL: Lock by decelerating.
ACCEL : Lock by accelerating.
Select with which fields to start and end editing using tape.
1F : Start editing with field 1 and end with field 2.
2F: Start editing with field 2 and end with field 1.
1F/2F: Start and end editing depending on the timing of command reception.
When editing in phase-synchronized mode with menu item 004 set to ON, select
the target phase synchronization accuracy.
ACCUR : ±0 frame accuracy
ROUGH: ±1 frame accuracy
Select the initial speed automatically set when carrying out DMC editing.
MANU : The speed determined by the rotation of the search dial
PLAY: Normal playback speed
STILL: Stationary
±0.03 to ±1, +2: Speed set in the range ±0.03 to +2 (select from +2, ±1, ±0.5,
±0.2, ±0.1, ±0.03)
Note
If you want to carry out DMC editing after setting this menu item, first press the
DMC/FEED and DELETE buttons simultaneously to turn off the DMC/FEED button.
Select what happens when an erroneous edit point is set.
MANU : A warning is given by flashing the DELETE button on the lower control
panel.
The operator must manually delete the unnecessary edit points or correct the
erroneous edit point.
NEG&E: When inconsistent edit points are set, such as when an OUT point is
before an IN point, or an audio OUT point is before an audio IN point, or when
too many edit points are specified, the previously set edit point is deleted.
NEG: When inconsistent edit points are set, such as when an OUT point is before
an IN point, or an audio OUT point is before an audio IN point, the previously
set edit point is deleted. When too many edit points are specified, the DELETE
button on the control panel flashes to give a warning.
Note
Pressing the button corresponding to an edit point to be deleted and the DELETE
button simultaneously, deletes the edit point. If an erroneous edit point is set (the
DELETE button is flashing), editing is not executed.
(Continued)