Gas Connection - DeLonghi DGS 61 ST User Operating Instructions Manual

The installation of the gas appliance to Natural Gas or LP Gas must be carried out
by a suitably qualified and registered installer. Installers shall take due account of the
provisions of the relevant British Standards Code of Practice, the Gas Safety Regulations
and the Building Standards (Scotland)(Consolidation) Regulations issued by the Scottish
Development Department.
Installation to Natural Gas
Installation to Natural Gas must conform to the Code of Practice, etc.
The supply pressure for Natural Gas is 20 mbar.
The installation must conform to the relevant British Standards.
Installation to LP Gas
When operating on Butane gas a supply pressure of 28-30 mbar is required. When
using Propane gas a supply pressure of 37 mbar is required.
The installation must conform to the relevant British Standards.
Warning:
Only a suitably qualified and registered installer, also with technical knowl-
edge of electricity should install the appliance. He should observe the Regulations and
Codes of Practice governing such installation of gas appliances.
Note: It is recommended that the gas connection to the appliance is installed with
a flexible connecting tube made to BS5386.
Notes:
Flexible hoses can be used where the sited ambient temperature of the

hose does not exceed 70°C. These hoses must be manufactured in
accordance with BS669 part 1 and be of the correct construction for the
type of gas being used.
 Gas hoses designed for natural gas MUST NOT be used for supplying LPG
gas (LPG gas hoses can be identified by a either a red band or stripe on
the rubber outer coating of the hose).
The hose should not be crushed or trapped or be in contact with sharp or
abrasive edges.

Gas connection

21