DeLonghi DGS 61 ST User Operating Instructions Manual page 29

GENER L NOTES
 The wires in the mains lead on this appliance are coloured in accordance with the
following code:
 s the colours may not correspond with the markings identifying the terminals in
your plug or in your spur box, proceed as follows:
The green and yellow wire must be connected to the terminal which is marked
with the letter E or with the earth symbol
The blue wire must be connected to the terminal marked N or coloured black.
The brown wire must be connected to the terminal marked L or coloured red.
 The power supply cord must not touch against any hot surfaces and must be placed
so that its temperature does not exceed 75°C at any point along its length.
 fter having installed the appliance, the power switch or power plug must always
be in a accessible position.
 The appliance must have its own supply; any other appliances installed near it must
be supplied separately.
 N.B. For connections to the mains power supply, never use adaptors, reductions or
multiple power points as these may overheat and catch fire.
 In the event that installation should require modifications to the mains supply wiring
system or if the power plug is not suitable for the type of power point available, it
is recommended that a qualified technician be called to carry out substitution. The
technician will also have to verify that the cross-section of the electric cables on the
power point match the appliance' s power rating.
 If the supply cord is damaged, it must be replaced by a special cord by a qualified
electrical technician in order to avoid a hazard.
FEEDER SPECI L C BLE SECTION
Type "H05VV-F"
230 V C 50/60 Hz
 The supply cable must be replaced with a cable of
the same type.
 The electrical cable must be connected to the
terminal board following the diagrams of Fig. 6.3.
Green and Yellow - Earth
Blue – Neutral
Brown – Live
3 x 0,75 mm
or coloured green and yellow.
2
230 V
PE
L1 N(L )
2
Fig. 6.3
29