DeLonghi DGS 61 ST User Operating Instructions Manual page 26

REGUL TION OF THE MINIMUM FL ME
This needs to be done only for the oven burner (the grill is a fixed capacity) by act-
ing on the thermostat.
Considering that in the minimum position the flame must have a length of about 4
mm and must remain lit even with a brusque passage from the maximum position
to that of minimum.
The flame adjustment is done in the following way:
 Light the oven burner by turning the knob on position
Let the oven pre-heat for about 10 minutes, then take the knob to position

(minimum) to operate at by-pass flow.
 Remove the thermostat knob and by means of a thin screwdriver pass by the hole
in the facia panel to unscrew of 3 turns the by-pass screw G (fig. 5.10)
 Slowly tighten the by-pass screw G (fig. 5.10) until you get a flame of 3-4 mm
long.
Turn off the burner and reassemble the knob.

fter regulation (always with oven hot and the oven door closed) check the sta-

bility of the flame with a passage from the maximum to minimum position.
The grill is a fixed capacity and does not need be adjusted.
N.B.: For Liquid gas (G 30/G 31) the screw G must be tightened thoroughly.
26
Fig. 5.10
G
.