DeLonghi DGS 61 ST User Operating Instructions Manual page 18

4
4
Ensure that air can flow freely around the housing area.
If the oven is being installed into a fully enclosed built under oven housing unit it
maybe necessary to cut a small slot in the top of the plinth fitted under the unit.
Cut a section 400 mm wide and a minimum of 15 mm high to allow air to pass
underthe unit.
Failure to allow adequate ventilation to
the appliance may result in over heat-
ing ordamage to adjacent units.
Lift the oven carefully into position on
the shelf, takingcare NOT to lift it by
the door handle. If you lower theoven
door, you will see 4 screw holes, 2 on
each sideof the oven. The oven should
then be secured to the housing byfit-
ting screws into these holes. Remember
the housing should not be free stand-
ingbut secured to the wall and/oradja-
cent fittings.
IMPORT NT: If the oven is being
installed into a built under oven hous-
ing unit ensurethat the front rail at the
top of the unit is not installed as it will
restrict ventilation.
18
Installation
W RNING
When correctly installed, your
product meets all safety require-
ments laid down for this type of
product category.
However special care should be
taken around the rear or the
underneath of
these areas are not designed or
intended to be touched and may
contain sharp or rough edges,
Fig. 4.2 that may cause injury.
Fig. 4.1
the appliance as