Appendix C Replacing Parts; Pad Assy; Pick Roller - Fujitsu iScanner fi-6010N Getting Started Manual

Appendix C
The glass scanner windows
AUTION
inside the ADF can become hot
when the scanner is used.
Before cleaning inside the
scanner or replacing any parts,
turn off the power, unplug the AC
adapter from the outlet, and wait
for at least 15 minutes.
■ Part No. and Replacement Cycle
for Consumable Parts
The usage count of consumable parts can be checked in
the "Usage Status" screen on the [Device Status] tab.
When parts need to be replaced soon, the "Status" infor-
mation field becomes orange. When parts need to be
replaced immediately, the "Status" information field
becomes red.
The following table specifies the replacement part num-
bers and the standard replacement cycles.
Part Name

PAD ASSY

(PA03289-0111)

PICK ROLLER

(PA03289-0001)
To obtain these parts, contact your FUJITSU dealer or
an authorized FUJITSU scanner service provider.
These replacement cycles are rough guidelines when
2
using 80 g/m (20 lb) A4/Letter woodfree or wood con-
taining paper. They may vary according to the type of
documents scanned, scanner usage, and cleaning fre-
quency.
Replacing Parts
Replacement Cycle
After every 50,000 sheets
scanned or once a year
After every 100,000 sheets
scanned or once a year
Use only the PFU LIMITED parts
ATTENTION
specified. Do not use consumable
parts made by other manufacturers.
The following diagram shows the locations of the con-
sumable parts in the scanner. For more details, refer to
the "Operator's Guide".
■ Pad Assy
■ Pick Roller
Pick roller
22
Pick roller's shaft