Checking The Network Connection; Restarting The System - Fujitsu iScanner fi-6010N Getting Started Manual

4. Enter the following numerical addresses:
Primary WINS
Secondary WINS
If a WINS server setting is not required, enter
"0.0.0.0".
A Secondary WINS cannot be set
without a Primary WINS.
ATTENTION
5. Press the [OK] button.
The information entered is set.
Next, check the network connection.
3.9 Checking the Network
Connection
The network connection may be checked by performing
a ping test.
1. Select the [Network Settings] tab on the top
menu.
2. Press the [ ] button on the left side menu.
Scroll the left side menu down until the [Ping]
tab appears.
3. Select the [Ping] tab on the left side menu.
The "Ping" screen appears.
4. Enter the IP address, host name, or FQDN for
the server to be used to check the network
connection.
For an IP address
The following format should be used
xxx.xxx.xxx.xxx (xxx is a value from 0 to 255).
For a host name or FQDN
Up to 255 characters may be used.
5. Press the [Ping] button.
A ping test is performed and the results are
displayed. If the result shows "Lost=0 (0%
loss)", the network connection is functioning
normally. For any other result, refer to
"Checking Basic Network Operation with a
Ping Test" (page 24).
After performing all settings, restart the system.

3.10 Restarting the System

1. Press the [Logout] button.
The restart confirmation screen appears.
2. Press the [Restart] button.
The scanner restarts, and the "Login" screen
appears.
Next, install the Admin Tool.
11