Optimise Standby; Refill Display; Check Filters - Miele Dishwasher Operating Instructions Manual

Settings menu

Optimise standby

To save energy, the diswasher will
switch off a few minutes after the last
time a sensor has been touched or a
few minutes after the end of the
programme.
The Optimise standby function can be
deactivated if wished. If Optimise
standby is deactivated, the dishwasher
will not switch off until 6 hours after the
end of the programme, resulting in
higher energy consumption.
^ Select the option you want and
OK
confirm with
If Optimise standby has been
activated, the clock will only be
displayed for a few minutes in
standby mode.
The dishwasher will not switch off if
salt or rinse aid needs to be
replenished or there is a fault.
If you only use combination
products containing salt and rinse
aid in your dishwasher, you can
switch off the reminders to replenish
salt and rinse aid so that the
dishwasher will switch off despite a
lack of salt or rinse aid.
You cannot switch off fault
messages.
82
!
.

Refill display

If you only ever use combination
products containing salt and rinse aid
in your dishwasher, you can switch the
salt and rinse aid refill reminders off if
you wish. The DetergentAgent function
will not be affected by this.
^ Select the option you want and
OK
confirm with
If you switch to using detergent that
does not contain salt or rinse aid, it
is important to remember to
replenish the salt and rinse aid and
to switch the reminders back on.

Check filters

You can adjust the interval at which the
reminder to check the filters appears.
You can set an interval of between 30
and 60 programme cycles.
The "Check filters" message is set at the
factory to appear after every 50
programme cycles.
^ Select the interval you want and
confirm this with
.
OK
.