Assembling And Hanging The Fan - Hunter T Owner's Manual And Installation Manual

Steps 3-1 – 3-2
Steps 3-3 – 3-4
Low Profile Washer
#8-32 x 1" Screw
3 • Assembling and Hanging the Fan
You can assemble your fan for standard mounting (steps 3-1 – 3-2)
or for low profile mounting (steps 3-3 – 3-4). Note: For low profile
mounting, the downrod is replaced with the low profile washer.
Downrod
3-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
Canopy
wires from the fan through the downrod.
3-2. Loosen the set screw. Screw the downrod into the fan assembly.
Canopy
Retighten the set screw. Skip to Step 3-5.
Trim Ring
CAUTION: The adapter has a special coating on the threads. Do
Set Screw
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-3. Place the low profile washer (lip up) into the canopy. Be sure the
green ground wire is pointing up toward the ceiling.
3-4. Align the holes in the washer with the holes in the adapter.
Assemble securely with three #8-32 x 1" screws.
3-5. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim. Go to 4 • Securing Fan to Secondary
Support System.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
8
41861-01 • 03/05/2010 • Hunter Fan Company
Step 3-5
U-shaped
Hole