Installing The Canopy And Canopy Trim; Ring - Hunter T Owner's Manual And Installation Manual

6 • Installing the Canopy and Canopy Trim Ring
6-1. Holding the canopy, raise the fan off the hook.
6-2. Align the slots in the canopy with the tabs on the ceiling plate.
6-3. Raise the canopy over the ceiling plate. Rotate the canopy
clockwise until the tabs on the ceiling plate totally engage with
the slots in the canopy.
6-4. Loosely assemble the three canopy screws into the canopy one at
a time. Once all three screws are in, tighten them.
6-5. Using both hands, push the canopy trim ring up to the top of the
canopy. The canopy trim ring will snap and lock into place.
Should you need to remove the canopy
trim ring, follow these steps:
1. Locate the tab indicators, small
bumps on top of tabs.
2. Press firmly on opposite sides of the
ring towards the canopy. The tabs
will flex out releasing the trim ring
from the canopy
Steps 6-4 – 6-5
11
41861-01 • 03/05/2010 • Hunter Fan Company
Step 6-2
Ceiling Plate
Canopy Trim
Canopy

Ring

Step 6-3
Canopy
Screw