Taillamps, Turn Signal, And Stoplamps; Back-Up Lamps - Chevrolet Corvette 2013 Owner's Manual

4. Remove the headlamp bulb by
releasing the outer tabs from the
socket.
5. Remove the front parking/turn
signal bulb by turning the bulb
socket counterclockwise.
6. Replace the high-beam
headlamp bulb with a new bulb
and reattach to the bulb socket.
Replace the front parking/turn
signal bulb by turning the bulb
socket clockwise.
7. Reverse the Steps 2 through 4 to
reinstall.
Taillamps, Turn Signal,
and Stoplamps
To replace a stoplamp, taillamp/turn
signal bulb:
1. Remove the screw from the top
of the lamp assembly.
2. Tilt the lamp assembly
toward you.
3. Turn the bulb socket one-quarter
turn counterclockwise and pull
it out.
4. Pull the bulb straight out to
remove it from the socket.
Vehicle Care
5. Push the new bulb in the bulb
socket until it snaps into place.
6. Reinstall the lamp assembly by
first lining up the tabs on the
bottom of the lamp assembly
with the tabs in the vehicle, then
slide it in.
7. Replace the screw at the top of
the lamp assembly.

Back-Up Lamps

WARNING
Exhaust system parts can be very
hot. Do not touch them. If you do,
you can be burned.
1. Reach under the rear fascia and
locate the back-up lamp
assembly.
2. Remove the bulb socket by
turning counterclockwise and
pulling straight out of the lamp
assembly.
3. Pull the bulb out of the socket.
10-43