Lamp Messages; Ride Control System; Messages - Chevrolet Corvette 2013 Owner's Manual

5-42 Instruments and Controls
The vehicle's battery voltage is
low. The battery voltage must be
above 10 volts for the RKE
transmitter to be detected
properly.
NO FOB - OFF OR RUN?
This message displays when the
RKE transmitter is not detected
inside the vehicle while you are
trying to turn the ignition off. The
vehicle may be near a strong radio
antenna signal causing the RKE
system to be jammed. The vehicle
will remain in ACCESSORY until the
vehicle is turned off or is restarted,
or five minutes has expired. If you
turn the ignition off and you cannot
find the RKE transmitter, you will not
be able to restart the vehicle. The
RKE transmitter needs to be inside
the vehicle in order for the vehicle to
start. See Starting the Engine on
page 9 20 for more information.
OFF ACCESSORY TO LEARN
See Matching Transmitter(s) to
Your Vehicle under Remote
Keyless Entry (RKE) System
Operation on page 2 3.
READY FOR FOB #X
See Matching Transmitter(s) to
Your Vehicle under Remote
Keyless Entry (RKE) System
Operation on page 2 3.

Lamp Messages

HEADLAMPS SUGGESTED
This message displays if it is dark
enough outside and the headlamps
and the Twilight Sentinel
are off. This message informs the
driver that turning on the exterior
lamps is recommended. It has
become dark enough outside to
require the headlamps and/or other
exterior lamps.
TURN SIGNAL ON
This message displays and a sound
will be heard if a turn signal is left
on for 1.2 km (three-quarters of a
mile). Move the turn signal/
multifunction lever to the off
position.
To acknowledge this message,
press the RESET button.

Ride Control System

Messages

ACTIVE HANDLING
This message displays when the
Active Handling System is
operating. The Active Handling
®
controls
System is a computer controlled
system that assists the driver in
controlling the vehicle in difficult
driving conditions. You may feel or
hear the system working and see
the ACTIVE HANDLING message
displayed in the DIC. This message
stays on for a few seconds following
the active handling event. This is
normal when the system is