Vehicle Messages - Chevrolet Corvette 2013 Owner's Manual

5-34 Instruments and Controls
If the ignition is on and the HUD
image cannot be seen, check to
see if:
Something is covering the
HUD unit.
The HUD dimmer control is
adjusted properly.
The HUD image is adjusted to
the proper height.
Ambient light is low, in the
direction the vehicle is facing.
A fuse is blown. See Fuses and
Circuit Breakers on page 10 45.
Keep in mind that the windshield is
part of the HUD system. See
Windshield Replacement on
page 10 41.

Vehicle Messages

Messages displayed on the DIC
indicate the status of the vehicle or
some action may be needed to
correct a condition. Multiple
messages may appear one after
another.
The messages that do not require
immediate action can be
acknowledged and cleared by
pressing the RESET button.
The messages that require
immediate action cannot be cleared
until that action is performed. All
messages should be taken seriously
and clearing the messages does not
correct the problem.
Battery Voltage and
Charging Messages
BATTERY SAVER ACTIVE
This message displays when the
vehicle has detected that the battery
voltage is dropping beyond a
reasonable point. The battery saver
system starts reducing certain
features of the vehicle that you may
be able to notice. At the point that
features are disabled, this message
is displayed. It means that the
vehicle is trying to save the charge
in the battery. Turn off unnecessary
accessories to allow the battery to
recharge.
BATTERY VOLTAGE HIGH
See Voltmeter Gauge on page 5 16.
BATTERY VOLTAGE LOW
See Voltmeter Gauge on page 5 16.
SERVICE CHARGING SYSTEM
If this message displays while you
are driving, there may be a problem
with the electrical charging system.
It could mean that there is a loose
or broken drive belt or that there is
another electrical problem. Have the
vehicle checked right away by your
dealer. Driving while this message is
on could drain the battery.