Chevrolet Corvette 2013 Owner's Manual page 255

Once the vehicle speed reaches
about 40 km/h (25 mph) or more,
move the cruise control switch
+
briefly from to . The vehicle
returns to the previous set speed
and stays there.
If the switch is held at resume/
accelerate, the vehicle keeps going
faster until the switch is released or
the brake is applied. Do not hold the
switch at resume/accelerate, unless
you want the vehicle to go faster.
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated,
Use the accelerator pedal to get
to the higher speed. Press
the end of the lever, then release
the button and the accelerator
pedal. If the accelerator pedal is
held longer than 60 seconds,
cruise control will turn off.
Move the cruise switch from to
+
. Hold it there until desired
speed is reached, and then
release the switch.
To increase the vehicle speed in
small amounts, move the switch
+
briefly to . Each time this is
done, the vehicle goes about
1.6 km/h (1 mph) faster.
Reducing Speed While Using
Cruise Control
If the cruise control system is
already activated,
Press and hold the set button
until the lower speed desired is
reached, then release it.
To slow down in small amounts,
at
briefly press
is done, the vehicle goes about
1.6 km/h (1 mph) slower.
Driving and Operating
Passing Another Vehicle While
Using Cruise Control
Use the accelerator pedal to
increase the vehicle speed. When
you take your foot off the pedal, the
vehicle will slow down to the
previous set cruise speed.
Using Cruise Control on Hills
How well the cruise control works
on hills depends upon the vehicle
speed, load, and the steepness of
the hills. When going up steep hills,
you might want to step on the
accelerator pedal to maintain the
vehicle speed. When going
downhill, you might have to brake or
shift to a lower gear to keep the
vehicle's speed down. When the
brakes are applied the cruise control
. Each time this
is disengaged.
9-43