Denon AVR-1683 Operating Instructions Manual page 39

6
1
o&h
Use the 0 (left) and 0 (rrght) buttons to set the D. COMP
\*
b
(Initial)
(left) button (right) button
Press the SURROUND PARAMETER or a (down) button to switch to the LFE setting.
NOTE:
This parameter IS not displayed during DTS playback.
7
/
O&
Use the 0 (left) and 0 (right) buttons to set the LFE level.
4 b
: :.... :....
i .G
: :...,
: :... L.. . . . . :..:
! . . . . i : . . . .
:I,,: :,,,g E,,,:
~Rernote control ulut~
l
The level can be adjusted rn unrts of 1 dB from -10 to 0 dB.
Set to the desrred level accordtng to the speaker systems being used and the source to be played.
Press the SURROUND PARAMETER or a (down) button to switch to the default settrng.
8
To reset the settings to the factory defaults, use the 0 (left) and 0 (right) buttons to display "Yes"
~, :.... ~. . . . . . ~ ~ ~ "?
: i
I.... L. !
: :... :... p..: : : :
'.:. : ..I.,:
. : '.... : . . . . :
;';
(j- -0
(left) button (right) button
Press the SURROUND PARAMETER or a (down) button to switch to the CINEMA EQ setting.
9
Press the ENTER button to finrsh surround parameter mode
Surround parameters @I
CINEMA EQ. (Cinema Equalizer):
The Cinema EQ function gently decreases the level of the extreme high frequencies, compensating for overly-bright sounding motion picture
soundtracks. Select this function if the sound from the front speakers is too bright.
This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes. (The same contents are set for all operating modes.)
D.COMl? (Dynamic Range Compression):
Matron picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night,
or whenever the maximum sound level IS lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the
soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital.) Select one of the four
parameters ("OFF", "LOW",
"MID" (mrddle) or "HI" (high)). Set to OFF for normal listening.
LFE (Low Frequency Effect):
Program source and adjustment range
1. Dolby Digital: -10 dB to 0 dB
2. DTS Surround: -10 dB to 0 dB
% When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 d6 for correct Dolby Digital
playback.
% When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 d6 for correct DTS playback.
% When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.