Denon AVR-1683 Operating Instructions Manual page 14

l
Connect the speaker terminals with the speakers makrng sure that lrka
polaritres are matched @ with @, @ with @I. Mrsmatchrng of polafrtjes wrll
result rn weak central sound, unclear orientatron of the various Instruments,
and the sense of drrectron of the stereo berng rmparred.
l
When making connections, take care that none of the rndivrdual conductors
of the speaker cord come rn contact with adjacent termrnals, with other
speaker cord conductors, or wrth the rear panel.
NOTE: I
Speaker Impedance
l
When speaker systems A and B are use separately, speakers with an
impedance of 6 to 16 Q/ohms can be connected for use as front speakers.
l
Be careful when using two parrs of front speakers (A + B) at the same time,
since use of speakers with an Impedance of 12 to 16 Q/ohms.
l
Speakers with an rmpedance of 6 to 16 Q/ohms can be connected for use
as center and surround speakers.
l
The protector circurt may be actrvated if the set IS played for long periods of
time at hrgh volumes when speakers wrth an Impedance lower than the
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
specrfied impedance are connected
Connecting the speaker cords
1. Loosen by turnrng
counterclockwrse
2 Insert the cord
3 Tghten by tumrng
clockwrse
1. Push the lever.
2 Insert the cord. 3 Return the lever
Connecting banana plugs
Turn clockwrse to tighten, then insert the
banana plug.
CENTER SPEAKER SYSTEM
FRONT SPEAKER SYSTEMS
System A
FRONT SPEAKER SYSTEMS
System B
If a speaker IS placed near a TV or vrdeo monrtor, the
colors on the screen may be drsturbed by the
speaker's magnetism If this should happen, move
the speaker away to a postion where it does not
have thus effect.
Connection jack for subwoofer wrth burlt-rn
amplifier (super woofer), etc.
.X To achreve Dolby Digrtal (AC-31 playback
effect, use a unit that can suffrcrently
reproduce frequencres of under 80 Hz.
SURROUND SPEAKER SYSTEMS
14