SECTION 6—OPERATING INSTRUCTIONS
FLOW SETTING
1
2
3
4
5
FIGURE 6.9 Adjusting the Pulse Flow Setting
Using the XPO
1. Turn the XPO
2. Breathe normally through your nose. Breathing through
your mouth may result in less effective oxygen therapy.
The XPO
will put out a measured pulse of oxygen each
2
time it detects inhalation. The blue flow setting indicator
light will blink each time an inhalation is detected and the
XPO
outputs a pulse of oxygen.
2
3. Turn the XPO
On/Off button for approximately two seconds.
NOTE: The time required for the XPO
concentration after being turned On is approximately 5 minutes.
Invacare XPO
™
2
AVERAGE PULSE VOLUME (AT 20
Indicator Lights
Flow Selection
Portable Concentrator
2
On by pressing the On/Off button.
2
Off by pressing and holding the power
2
BREATHS PER MINUTE)
15 ml
23 ml
31 ml
37 ml
42 ml
On/Off Button
to reach maximum oxygen
2
32
Part No 1148112