Cleaning & Maintenance; Storage; Troubleshooting - Kenmore 408.91200310 Use & Care Manual

CLEANING AND MAINTENANCE
WARNING: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE
HEATER AS THIS COULD CREATE A FIRE OR ELECTRIC SHOCK HAZARD, OR
DAMAGE THE UNIT.
1. Perform the cleaning procedures described in "CLEANING AND
MAINTENANCE"
2. Wipe all parts dry.
3. Pack the heater in a plastic bag and store it in a cool, dry place.
If your heater fails to operate, follow these procedures before contacting
customer service:
Problem
Unit is not
heating.
The heater is
creating a
burning smell.
DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING
SO WILL VOID THE WARRANTY AND MAY CAUSE DAMAGE OR PERSONAL
INJURY.

STORAGE

TROUBLESHOOTING

Probable Cause
The room temperature has
warmed up to thermostat
setting.
Tip-over switch has been
activated due to the unit
tipping over.
A drop of oil may have
fallen on the heating
element during the
manufacturing process. It
will quickly evaporate and
should not occur again.
Check and ensure there
are no combustible
materials within 3 feet
(0.9 meters) of the heater.
Adjust the thermostat control
knob to a higher setting. For
more information on using the
thermostat, refer to page 6.
Put the unit back to normal
upright position and plug
back in.
To eliminate oil smell if it
occurs, ensure room in which
heater is situated is well
ventilated.
Remove any combustible
items from the vicinity of the
heater.
8
Solution