Parts Of The Heater - Kenmore 408.91200310 Use & Care Manual

•
This heater draws 10.0 amps during operation. To prevent overloading a
circuit, do not plug the heater into a circuit that already has other
appliances working.
•
Do not run in locations when the heater will be left unattended for long
periods of time. (For example - in an unoccupied summer cottage).
•
Do not use attachments. They are not recommended.

PARTS OF THE HEATER

1. Blue LED
2. Thermostat
3. Red LED
4. Power indicator light
5. Safety grille
6. Rear grille
7. Filter
To operate, connect to a properly polarized outlet only. Match wide blade of
plug to wide slot and fully insert. Be sure to plug into a 120V AC, 60Hz outlet.
NOTE: THE HEATER WILL NOT OPERATE UNTIL THE POWER CORD OF THE
UNIT IS PROPERLY PLUGGED INTO A POLARIZED OUTLET AND POWERED
ON (SEE SECTION ON POLARIZED PLUGS UNDER IMPORTANT
SAFEGUARDS).
YOUR HEATER IS EQUIPPED WITH ONE THERMOSTAT CONTROL.
IMPORTANT SAFEGUARDS
PARTS OF THE HEATER
OPERATING INSTRUCTIONS
1
2
4
5
5
3
6
7