Table of Contents
Advertisement
INSTALLING THE BELT
1. To replace sanding belt, push the idler pulley assembly (Item 2) towards the
handle until it clicks into the secured position. Replace the belt and press
the tension bar (item 14), to re-tension the belt (see Fig 1
2. To track the belt, adjust as required with screw and locknut (2A in Fig 1).
3. To adjust the handle position, slacken the screw (item 11), rotate the
handle to the required position. (Only as far as A or B), then secure by re-
tightening the screw (item 11).
4. Connect to the airline and turn the air on.
5. Ensure your fingers are clear of the sanding belt. Squeeze the throttle lever
to start the motor. Allow the motor to reach max speed before offering the
belt to the workpiece.
6. Do not use the finger pad (Item 4) to exert pressure on the belt; this item is
only for guiding the tool.
7. When finished sanding, release the throttle lever and allow the motor to
stop before carefully putting the tool down.
• Only use sanding belts designed for use with this type of sander
OPERATING
1. Squeeze the trigger against the body of the tool to start the sander and
control the speed. Evaluate the speed and adjust to suit.
2. To begin work, rest the belt on the workpiece and start the sander.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
8
Advertisement
Table of Contents
