Viking 24" Installation Manual page 21

3
Attach with screws and lock washers provided.
5
Remove electrical box cover.
6
1
Flip hood over. Insert 6" of electrical wiring through the
top of vent hood and secure. Refer to local codes.
40
4
Attach with screws.
W A R N I N G
To reduce the risk of fire, electric shock, or injury
to persons, observe the following:
• Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact
the manufacturer.
• Before servicing or cleaning unit, switch power off
at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.
7
CAUTION: Secure vent hood. Make sure mounting
screws are secured into framing. Use additional
mounting screws and wall anchors, if necessary.
8
BARE OR GREEN
GREEN
BLACK
WHITE
BLACK
WHITE
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE: Housing wiring must be properly installed for
wiring to be correct when wiring unit.
10
Assemble brackets to baffles and insert charcoal filters.
12
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
41
9
1
2
Replace electrical box cover. Make connection to
breaker box.
11
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
13
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.