GE PGS908 Technical Service Manual page 36

To remove the lockout valve:
1. Remove the oven door. (See
2. Remove the range from the installation. (See
.)
Range Removal
3. Remove the rear cover. (See
4. Remove the two 1/4-in. hex-head screws and
the lockout valve cover.
Lockout
Valve
5. Disconnect the wires from the lockout valve.
6. Using an 11/16-in. wrench, disconnect the inlet
and outlet tube hex-head nuts from the valve.
.)
Oven Door Removal
.)
Rear Cover Removal
Cover
Disconnect
Wires
– 36 –
7. Carefully remove the tubes from the valve.
8. Remove the 1/4-in. hex-head screw that
attaches the valve to the range.
Note: When installing the lockout valve, be sure that
the cutout in the bottom of the valve is engaged
behind the tab on the back of the range.
Cutout
Tab