Careand Cleaning Of The Range; Control Knobs; Burner Assembly; Packaging Tape - GE JGS968 Owner's Manual

Careand cleaning of the range, www.GEAppliances.com
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is reengaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
How to Remove Packaging Tape
To assure no damage is done to the finish
ot the product, the satest way to remove
the adhesive left fl'om packaging tape
and cooktop labels on new appliances
is an application of a household liquid
dishwashing detergent, mineral oil or
cooking oil.
Apply with a soft cloda and allow to soak.
Wipe (h T and then apply an appliance
polish to thoroughly clean and protect
the surti_ce.
NOTE: Theadhesive must be removed from all
parts. It cannot be removed if it is baked on.
Control Knobs
Thecontrol knobs may be removed for easier
cleaning.
Before removing the knobs tot
cleaning, please note that the knobs are
in the Off position. When replacing the
knobs, check the
OFF
position to insm'e
proper placement.
_'ash the knobs in soap and water or a
vinegar and hot water solution but (lo
not soak.
Grate
Burner cad
Burner nea0
Electrode
-'_ Burner uase
CAUTION:DO NOT OPERATE THE
BURNER WlTHOUTALL BURNER
PARTSIN PLACE.
Burner Assembly
The 1)urner assemblies should be washed
regularly and, of coui_e, after spillovei_.
Turnall controls off before remowng burner parts.
The 1)urner grates, 1)urner
heads and
btlI'neY caps can
be
i'ei//oved ilk)i" easv
cleaning.
The electrode (ff the spark ignitor is
eN)osed beyond the Stli-[ilce (ff the
btlrner base. \,_]/ell
cleaning tile cooktop,
be carefld not to snag the electrode (ff
the spark igniter with yore" cleaning
cloth. Damage to the igniter could occm:
Toavoid snagging a cloth on the spark
igniter, leave the burner heads in place
when cleaning the cooktop.
Be careful not to push in any cooktop
controls while cleaning the cooktop.
A slight electrical shock might result
which could cause you to knock over
hot cookware.
Wash burner
parts
with an allI)uq)ose
non-abi'asive cleaner and W[liil/watei:
Soak stubborn soil. Dry them with a
cloth--<lo not reassemble while wet.
To reassemble, replace the burner head
first, then the burner cap and finally the
burner grate. Be sure the
pins
in the
burner head are properly located in the
btlrner base holes.
31