Meat Probe Outlet - GE PGS908 Technical Service Manual

7. Disconnect the 3 wires from the fan motor.
8. Remove the three 1/4-in. hex-head screws that
attach the fan motor to the range.
Disconnect
Wire
PGS975 Convection Fan Circuit
CONVECTION BAKE
L1
DBL RELAY
Convection Fan Notes:
• The convection fan will not come on while there
is a call for heat from the oven temperature
sensor (gas burner on).
• The fan will only start to operate 10 seconds
after the burners turn off.
• The fan will only run in one direction.
If convection fan is not working, make the following
checks:
• Check to make sure the fan shaft is not rubbing
on the oven liner.
• Check the convection fan motor resistance.
Disconnect
Wires
N
LOW SPEED
HI SPEED
CONVECTION
MOTOR
– 46 –

Meat Probe Outlet

The meat probe outlet (some models) is located near
the top right corner of the oven cavity. To access the
probe outlet, open the oven door and remove the
two 1/4-in. hex-head screws that secure the outlet
to the oven liner.
The outlet and wiring can then be pulled down from
the oven wall approximately 1½ inches.
Note: When replacing the meat probe outlet, cut
the probe wires and splice the new probe using
approved heat resistant connectors.
Cut Here
Cut Here