Wiresless Command Center - iRobot Roomba 500 Series Owner's Manual

Wireless Command Center
(optional accessory for selected models)
The Wireless Command Center lets you conveniently control Roomba's
functions. You can use it to turn Roomba on and off, schedule Roomba to
clean, and steer Roomba around your room.
Troubleshooting
Battery
Indicator
Roomba spirals approximately three feet in diameter and then spirals
back to where it started, intensely cleaning a local area.
Roomba automatically calculates the room size and adjusts its
cleaning time appropriately.
Models
. . .
570-599
Models
600+
Wireless Command Centers are set up to control only one Roomba. To pair
a Wireless Command Center with a Roomba, you need four "AA" batteries
(not included).
1
Make sure Roomba's battery is fully charged.
2
3 Install three "AA" batteries into the Command Center.
4 Hold down the left drive button while installing the fourth battery.
5 Continue holding the button for 3 seconds or until the days of the
week lights flash in a sequence from right to left (Saturday to Sunday).
6 Install the battery door and place the Command Center on top of
Roomba.
7
for 2 seconds. The lights on the Command Center will flash to indicate
the pairing has completed, and Roomba will make a two-tone beep.
8 When the Command Center is powered on from now on, the lights will
flash in sequence from left to right until Roomba is under control.
18 iRobot Roomba 500 Series
...
Roomba attempts to dock on the Home Base, if present.
Roomba enters Max mode and cleans as long as the
battery allows.
. . .