Hand Activated Wheel Lock Procedures - Invacare Orbit 1073955 Owners Operating & Maintenance Manual

SECTION 10—ANTI-TIPPERS/WHEEL LOCKS
Wheelchair
Frame
Wheel Lock
Clamp
Set Screws
FIGURE 10.1 Foot Activated Wheel Lock Procedures

Hand Activated Wheel Lock Procedures

Installing/Removing Hand Activated Wheel Locks
NOTE: For this procedure, refer to FIGURE 10.3 on page 67.
1. Remove the foot activated wheel lock.
Refer to Installing/Removing Foot
Activated Wheel Locks on page 65.
2. Do one of the following:
• For 12‐inch Rear Wheels: Position
the wheel lock assembly on the
LOWER tube of the frame.
• For 20, 22, or 24‐inch Rear Wheels:
Position the wheel lock assembly on
the upper tube of frame.
3. Loosely tighten the two socket screws
that secure the wheel locks to the
wheelchair frame.
4. Adjust the wheel locks. Refer to
Adjusting the Wheel Lock on page 67.
5. To remove the wheel locks, unthread
the socket screws and remove wheel
lock from the wheelchair frame.
™
Orbit
Lower Tube of
Wheelchair
Frame
Foot Activated
Slider
Wheel Lock
Bar
Assembly
NOTE: A portion of the Release Lever is cut
away to show a better view of the slider bar.
12-inch Rear
Wheel
Lower Tube
of Frame
20, 22, 24-inch
Rear Wheel
FIGURE 10.2 Installing/Removing Hand
Activated Wheel Locks
66
Crossbar
Wheel Lock
Clamp
Release
Vertical Tube
Lever
Socket
Screws
Hand
Activated
Wheel
Lock
Upper Tube
of Frame
Part No. 1073955