Invacare Orbit 1073955 Owners Operating & Maintenance Manual page 49

Installing/Removing/Adjusting Catilever Arms
NOTE: To remove, reverse this procedure.
NOTE: When removing the locknuts and washers from the cantilever arm assembly, leave the top
mounting screw, coved washers and spacer (between adjustment plate and cantilever arm) in place.
1. Slide the partially assembled cantilever arm assembly with mounting hardware
through the back cane. Make sure the adjustment plate is towards the inside of the
wheelchair.
NOTE: This includes top mounting screw, coved washers and spacer (between adjustment plate
and cantilever arm).
2. Slide the bottom mounting screw (with coved washer) through the adjustment plate
and back cane.
3. Securely tighten the cantilever arm to the wheelchair with two locknuts and washers.
Adjustment
Actuator
Bottom
Mounting
Screw
FIGURE 6.9 Using/Installing/Adjusting Cantilever Arms
Part No. 1073955
Coved
Washers
Plate
Spacer
Top Mounting Screw
and Coved Washer
Back Cane
Washers
Cantilever Arm
49
SECTION 6—ARMS
Locknuts
Orbit
™