Connection
Connecting to Power
Each model has different power specification. Please check the name of the
model and power specification before connecting to power source.
For AC / DC Power Type
• The wire is polarized. Be sure to connect the
wire that white line is on covering to '-'
terminal and connect the other one to '+'
terminal.
• Use AC 24V/300mA or DC 12V/500mA
power source for SHC-721AN/AP
Resistance of copper wire [at 20C˚ (68˚F)]
2
Copper wire size (AWG)
#24(0.22mm
)
#22(0.33mm
Resistance (Ω / m)
0.078
Voltage Drop (V/m)
0.028
• As the voltage drop according to the length of the cable in the above table, a
camera may malfunction if there is an excessively long cable run.
* Voltage for camera operation: 12V DC ±10%
* Voltage drops in the above table are variable according to types of cable manufacturer.
For High Voltage Type
• The wire is non-polarized.
• Use AC 230V~, 50Hz power source for SHC-721APH
Notes
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
20
COLOR CCD CAMERA
2
2
2
)
#20(0.52mm
)
#18(0.83mm
)
0.050
0.030
0.018
0.018
0.011
0.006
User's Manual
Operating Your Camera
Configuration of The Menu
SETUP MENU
CAMERA ID (see page 23)
• OFF
• ON
BACKLIGHT (see page 26)
• WDR
• BLC
WHITE BAL. (see page 27)
• W-ATW
• S-ATW
MOTION DET. (see page 28)
• OFF
• MD1
LENS (see page 32)
• DC / Video • Manual
SHUTTER (see page 33)
• OFF
• 1/100 (1/120)
SENSE UP (see page 35)
• Auto
• OFF
GAIN (see page 36)
• OFF • AGC-L • AGC-H
SSNR (see page 36)
• OFF • LOW • MIDDLE • HIGH
SPECIAL (see page 37)
• COLOR
• SYNC
• END
• EXIT
EXIT
COLOR CCD CAMERA
• OFF
• AWC
• MANUAL
• MD2
• ESC
• MANUAL
• PRIVACY • PRESET
21
User's Manual