Adjust The Panning And Tilting, Rotating While Watching The Monitor; Connection; Connecting To Monitor; Connecting To Power - Samsung SID-47 User Manual

Installation
4) When an image on the screen is in focus, tighten the lens hold screw with proper strength so
as not to break out the screw.
5) Please change the EFL in LENS SAHDE menu after changing the lens, so that the function
operates properly.
* Please use a suitable screwdriver for the size of screw.

Adjust the panning and tilting, rotating while watching the monitor

174˚
176˚
Pan Base
176˚
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 176° to each side direction and 352° on the whole.
• Tilt Base covers 75˚ angle.
• Rotate Base moves by 174° to each side direction and 348° on the whole.
2) Methods of adjustment
• The case of wall installation
... 1 After mounting the camera on a wall, adjusting the panning angle so that the camera can
face the direction to monitor when tilting.
And then adjust the tilting angle by rotating the tilt base.
... 2
Loosen the rotate base hold screw and adjust rotate base for the best monitoring.
... 3
Tighten tilt and pan base hold screw.
...
4
• The case of ceiling installation
After mounting the camera on a ceiling, adjusting the panning angle for better monitoring
... 1
area by rotating the pan base.
And then adjust the tilting angle by rotating the tilt base.
... 2
Loosen the rotate base hold screw and adjust rotate base for the best monitoring.
... 3
Tighten tilt and pan base hold screw.
... 4
12
COLOR DOME CAMERA
75˚
174˚
Tilt Base
Rotate Base
User's Manual

Connecting to Monitor

Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
CCTV Camera
• As the connecting method varies with the instruments, refer to the manual supplied with the
instrument.
• Only connect the cable when the power is turned off.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate device.
CCTV Camera

Connecting to Power

Connect the adaptor to the power input connector as shown in the figure below. The
recommended adaptor specification for SID-47N/47P, SID-48N/48P, SID-49N/49P is AC 24V / 300mA
or DC 12V / 500mA.
---- Power Input Terminal
COLOR DOME CAMERA

Connection

Monitor
Intermediate End monitor
13
User's Manual