Mitsubishi Electric 900D-ID Operation Manual page 9

2 2 2 2 2
INSTALLING THE INK CASSETTE
1 1 1 1 1
Eliminate any slack of the ink sheet.
Hold the colored roller and turn the white roller.
2 2 2 2 2
Insert the ink cassette with the ink sheet into its
compartment.
Put the ink cassette with flat top side to each
other side (with handle) as shown right. When exchanging the
ink sheet, remove the cassette by holding the handle.
2 2 2 2 2
INSERT THE PRINTING UNIT
1 1 1 1 1
Push the printing unit until it is locked into place.
2 2 2 2 2
After plugging the power cord, press POWER button on the
front panel.
3 3 3 3 3
Press FEED&CUT button.
The print paper is automatically cut after feeding about 10 cm (4
inches).
4 4 4 4 4
Repeat the above step
Feeding the print paper will eliminate fingerprints and dust during
handling. The printing unit is initialized.
An IC is built in the ink sheet. This is the IC chip, not a battery.
This IC is safe to be thrown away with normal waste.
1
. Then, set the
3 3 3 3 3
once or twice.
NOTE
1
1
2
2
9