Connecting Devices - Mitsubishi Electric 900D-ID Operation Manual

CAUTION ON RELOCATING
When transporting this unit, make sure it is not likely to be subjected to impacts. They can be a prime cause
for damage. Also, make sure to disconnect the power cord from the power outlet, and all cables from the
devices.

CONNECTING DEVICES

Read thoroughly "Operating Precautions" of the instruction booklets for the devices connected with the
Digital color printer.
The power cord must be disconnected after printing is over.
Dust or other foreign matter adhering to the print paper or the sheet cartridge, or deformation resulting from
exposure to extremely low or high temperatures could cause loss of colour, uneven colour or lines, or
wrinkles in the print images.
NOTE:
YOUR UNDERSTANDING IS REQUESTED FOR THE LOSS OF IMAGES IN MEMORY DUE TO THE
SUDDEN OCCURRENCE OF A MALFUNCTION.
1.To use the Compact Flash,
1. Insert a Compact Flash into the camera.
2. Turn on the power.
To pull out a Compact Flash,
1. Turn off the power.
2. Pull out the Compact Flash.
2. When a Compact Flash is inserted or pulled out during power on status, the Compact Flash and the
camera may be damaged.
Make sure to turn off the power when inserting or pulling out the Compact Flash.
3. Compact Flashes recommended
Manufacturer : Mitsubishi, SanDisk, LEXAR
Capacity : 8M byte, 16M byte, 32M byte, 64M byte
• Compact Flash is a trademark of SanDisk Corporation.
OTHER CAUTIONS
WHEN USING A COMPACT FLASH
TM
The camera is turnd on
with a CF inserted
without a CF inserted
CF is available.
CF is not available.
* CF : Compact Flash
5