Mitsubishi Electric 900D-ID Operation Manual page 8

3 3 3 3 3
Remove the seal, and insert the edge of the print paper
right below the roller cover with arrow marks towards the
front panel.
Make sure to insert the paper straight.
4 4 4 4 4
Feed the print paper through the paper outlet by hand.
5 5 5 5 5
Pull both sides of the print paper to eliminate slack.
INSTALLATION OF INK SHEET
2 2 2 2 2
INSTALLING THE INK SHEET
Load the ink sheet into the cassette before inserting the cassette
into the printer.
1 1 1 1 1
Put the ink sheet rollers with flat tops into the holes of ink
cassette.
Put the white roller (rolled with ink sheet) to the ink cassette first.
Then, put the colored roller (without ink sheet) to the ink
cassette.
2 2 2 2 2
Position the other sides of rollers. Set IC at this time.
IC chip with the IC holder is attached to the ink sheet.
Set the IC holder to the ink cassette as shown right.
• Do not remove the IC chip or IC holder from the ink sheet.
Removal of the IC will stop the printer from functioning
correctly.
• Set the projected part of the IC holder to the correct position
as shown below.
8
Projected part
NOTE
Paper
Paper
colored roller white roller
arrow marks
Paper
IC holder