Table of Contents
Advertisement
MAINTENANCE
Checking the drive axle and flange
washers
Check that the threads on the drive shaft are undamaged.
Check that the contact surfaces on the blade and the flange
washers are undamaged, of the correct dimension, clean,
and that they run properly on the drive axle.
Do not use warped, notched, indented or dirty flange
washers. Do not use different dimensions of flange washers.
Below you will find some general maintenance
instructions.
Daily maintenance
1 Check that nuts and screws are tight.
2 Check that the power switch unit works smoothly.
3 Clean the outside of the machine.
4 Checking the blade guard
5 Check the condition of the cutting blade.
6 Check and clean the cooling air openings
7 Check that the cord and extension cord are intact and in
good condition.
16 –
English
Advertisement
Table of Contents
