Travis Industries 520-96 Owner's Manual page 43

REPLACEMENT PARTS AND REMOVAL INSTRUCTIONS
(Continued)
Removing and Replacing the Glass
DO NOT OPERATE THE APPLIANCE WITH BROKEN OR MISSING GLASS. IF THE GLASS DOES
BREAK, FOLLOW THE DIRECTIONS BELOW FOR REPLACING THE GLASS.
To replace the glass, first remove the door cam assembly by removing the nut with a 9/16" wrench. Then
remove the ten screws holding in the glass retainger with a 5/16" nut driver. Replace only with Neoceram
5mm thick, available from your dealer.
Unscrew the ten screws on the glass bracket with a 5/16" nut driver. Pull the glass retainer, glass, and
glass gasket away from the door. Replace the glass with Travis Industries Inc. replacement glass
(available at your dealer). The replacement glass is high temperature, high shock ceramic glass. When
re-installing, make sure the gasket is properly aligned ..
Hinge Pins
Remove the ten
screws holding in the
glass retainer with a
5/16" nut driver
Door Gasket
Glass
Removing and Replacing the Glass Gasket
A damaged or deteriorated glass gasket will allow air to enter the appliance through the space between
the door and glass. This may cause smoke to enter the room and hamper efficient burning. To replace
the glass gasket, follow the directions for removal of the glass and when re-installing, place the new
gasket in place.
Removing and Replacing the Door Gasket
A damaged or deteriorated door gasket will allow air to enter the appliance through the space between
the door and firebox. This will allow smoke to enter the room and hamper efficient burning. The door
gasket is held in place with special cement made to withstand extreme heat. To remove the gasket,
carefully pull the gasket away from the door and scrape any excess cement off the door. To replace, use
the manufacturer's gasket and cement (provided by your dealer) and re-attach the gasket, making sure it
is aligned properly around the opening.
DOOR
Door Cam &
Assembly
Page 43