Travis Industries 520-96 Owner's Manual page 45

REPLACEMENT PARTS AND REMOVAL INSTRUCTIONS
(Continued)
Removing and Replacing the Firebricks (Continued)
REMOVING THE SIDE AND BACK FIREBRICKS
1. Follow the directions for removing
the floor firebricks.
2. Once the bottom firebricks are
removed, the side and back
firebricks can be pivoted out from
behind the metal clips that hold the
firebricks in place. Grasp the
bricks, one at a time, from the
bottom and pivot them out from the
bottom. See the diagram to the
right to see the order of removal.
3. To replace the side and back
firebricks, follow these directions in
reverse order, placing the bricks
snug against each other and
against the walls of the firebox.
REMOVING THE BAFFLE (TOP) FIREBRICKS & COMPONENTS
1. Make sure the appliance is
cool and cleaned out.
2. Remove the door by opening
it and pulling it upwards.
Make sure to grasp the door
by both ends. It is heavy and
can be damaged.
3. Take a close look at the
exploded view for this section
(two pages down). Note the
position of the Front Baffle
Angle (referred to as the "Y"
Bar). It must be lifted and
rotated to expose the first line
of firebricks. Note the
drawing titled "Rotating the Y-
Bar" to see the before and
after affect of rotating the Y-
Bar. When rotating the Y-Bar
you will force the first row of
bricks to form a slight angle.
Metal clips that hold firebricks in place
10
5
2
6
1
5
6
2
1
Page 45
9
8
7
11
4
3
7
4
3