Travis Industries 520-96 Owner's Manual page 9

FREESTANDING OPTIONAL EQUIPMENT (Continued)
3. & 4. Brass and Cast Legs Assembly:
Open the box marked Brass (or Cast) Leg Kit and remove the four 7 7/8" high legs, complete with rubber-
tipped leveling bolts, the four attachment bolts (3/8" diameter - 16 x 3/4" hex. head bolts) and the washers.
Use the same directions listed above for the steel legs assembly. The one difference is that the brass (or
cast) legs are taller, and the stove should be lifted approximately 8 1/2" above the floor before attachment.
5. Blower, Rear
The rear blower is designed to improve the natural convection of the stove by pushing air through the
convection chamber of the stove and causing the heated air to exit through the vents along the top of the
stove. The blower mounts to the back of the stove centered on the lower edge with three screws. It also
has a thermodisk assembly which turns the blower on and off automatically. Follow the directions below
to attach the blower.
1. Before installing the blower, first remove the two knock-outs on the bottom rear edge of the stove by
prying them out with a screwdriver. They are approximately 1" by 6" and are located near the rear
edge of the stove.
2. Feed the two wires coming from the thermodisk assembly through the stove and out the left side
knock-out that was removed in step 1. Take the thermodisk assembly and insert it directly below the
ashlip into the left side of the air intake. The thermodisk assembly should be positioned just behind
the support tab that sits at an angle to the left front corner.
Feed wires through stove and
out the left knock-out
removed in step 1.
Attach Bolt (with
washer) to Stove
From Below
Support Tab
Remove these knock-outs for the
universal rear blower.
Do not remove. The front knock-out
is for the outside air connection.
Front of Stove
Page 9