Aastra 6863i Installation Manual page 16

Sip ip phone

Hide thumbs Also See for 6863i:

Table of Contents

Installation and Setup

Loosen the screws from the existing telco wall plate enough so that the Wall Mount Base is able to slide in place.

Remove the screws from the existing telco wall plate entirely and replace with a set of the provided screws. Ensure

that the screws are loose enough so that the Wall Mount Base is able to slide in place.

Note:

Depending on the wall type, you may need to use wall anchors. Two wall anchors are included with your 6863i IP

Phone

Align the Wall Mount Base above the screw heads (ensuring the Vertical Screw Lock Hole is facing up) on the telco

wall plate and pull down to lock the Wall Mount Base in place.

Telco

Wall

Plate

On the back of your phone, connect the provided Ethernet cable into the network port marked with

other end of the Ethernet cable directly into the network jack on the wall.

Align and Pull Down

Wall Mount Base Secured

to Telco Wall Plate

. Plug the

41-001505-00 REV00 – 04.2014

Table of Contents