SSC21WEB-1
2004.8.25
3-4) DISPLAY MENU function setting
5:38 PM
Page 27
If the time is set for each camera channel by using œ œ ENTER√ √ SWITCH, each camera picture will be
displayed for the set time and switched to the next picture automatically.
•
Function: Allows users to select the color and ON/OFF of borderline at QUAD DISPLAY.
Setting method: Move to #4. DISPLAY SETTING MENU by using œ œ ENTER√ √ SWITCH at
•
SETUP MENU, then press the ENTER SWITCH to display the OSD as shown in the figure below.
(The figure shows the initial setting status.)
06/01/03
13:14:00
DISPLAY
SETTING
BORDER
ON
BORDER COLOR
GRAY
PIP POSITION
B-RIGHT
NETWORK STATUS
ON/OFF
Move to each item by using œ œ ENTER√ √ SWITCH, and change the set value.
1) BORDER item determines whether or not boarder line is displayed at QUAD DISPLAY MODE.
(ON: Displays the boarder line, OFF: Does not display the boarder line)
2) BORDER COLOR item sets boarder line color among three colors: Black, White, Gray.
3) PIP POSITION item sets the location of sub picture at PIP DISPLAY. (T-LEFT: Upper part of left
side, T-RIGHT: Upper part of right side, B-LEFT: Lower part of left side, B-RIGHT: Lower part of
right side)
4) NETWORK STATUS determines the display of [S], [D], [P] displayed at the left of top on the
screen according to status of NETWORK.
Refer to 3-7) NETWORK SETTING function and setting method for the respective detailed status.
(ON: Displays the NETWORK STATUS, OFF: Does not display the NETWORK STATUS)
Eng-27