List Of Menu And Submenu Items - DURKOPP ADLER 580 Operating Instructions Manual

10.5.4 List of menu and submenu items

Menu item Description
Buttonhole number: up to 50 different buttonholes can be programmed.
Taper tack selection: buttonholes with taper tack (1), cross tack (2), round tack (3), and
without tack (0) as well as eyelet (4) can be programmed.
Length adjustments
Sewing length: the sewing length can be set from 6 to 42 mm, depending on the
equipment.
Eyelet diameter*: the internal diameter of the eyelet can be set from 2 to 7 mm, depending
on the equipment.
Stitch length in the lip: the distance from stitch to stitch within the lip (from 0,5 to 2 mm).
Number of stitches in the eyelet*: the number of the stitches that are evenly distributed
over the entire eyelet.
Eyelet overlap*: the overlapping of the seam beginning and the seam end.
Thread trimming length: with the Subclass 580-112000 / 0580-312000, it is possible to
alter the length of the needle thread on the underside of the buttonhole .
Condensed stitches increase the sewing security at the seam beginning and seam end.
Length of the condensed stitches at the seam beginning: the distance from stitch to
stitch within the stitch condensation at the seam beginning.
Length of the condensed stitches at the seam end: the distance from stitch to stitch
within the stitch condensation at the seam end.
Number of condensed stitches at the seam beginning: the number of stitches within the
stitch condensation at the seam beginning.
Number of condensed stitches at the seam end: the number of stitches within the stitch
condensation at the seam end.
Needle thread tension
Sewing tension: the sewing tension regulated electronically during the sewing cycle.
Trimming tension: remaining needle thread tension for the needle thread trimmer .
Tension at the sewing start: needle thread tension at the seam beginning.
36