Threading The Looper Thread - DURKOPP ADLER 580 Operating Instructions Manual

Hide thumbs Also See for 580:
Table of Contents

Advertisement

3.5

Threading the looper thread

looper thread
gimp thread
14
Caution: Danger of injury !
The looper thread must only be threaded in when the machine is switched
off or in the "Threading mode" (see chapter "Threading mode").
The automat must be in its final position, i.e. the looper turret with the
loopers has to point to the front.
Remove the clamping plates (see chapter 3.2).
Swivel the automat upwards.
Thread in the looper thread according to the illustrations with the
help of the long threading wire included in the accessories.
Leave an approx. 25 mm long looper thread end hang out of the
stitch hole of the throat plate.
Insert the clamping plates (see chapter 3.2).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents