Swivelling The Automat Up And Down - DURKOPP ADLER 580 Operating Instructions Manual

4

Swivelling the automat up and down

1
16
Caution: Danger of injury !
The automat must only be swivelled up when the machine is
switched off or in the "Threading mode" (see chapter "Threading
mode").
For various operations (e.g. for threading the looper thread or the
gimp thread) the automat has to be swivelled up.
Swivelling up:
–
Pull the locking bolt 1 and lift the automat at the front.
–
Let the locking bolt 1 go again and let it click into one of the
drill-holes (maybe you have to move the automat up and down a
little).
–
You should not let the automat go before the locking bolt 1 has
snapped in.
Swivelling down:
–
Keep hold of the automat and pull the locking bolt 1.
–
Swivel the automat down slowly.
Important !
When the automat is swivelled up very high, the effect of the
gas-pressurized spring that is to slow down the downward
movement is rather low at first. Therefore keep hold of the automat
when you swivel it down.
Operating the automat when it is swivelled up can lead to injuries and
damage.