Qlink Rodeo 90 User Manual page 8

•Always use proper procedures if you stall or roll backwards when climbing a hill. To avoid stalling, maintain
a steady speed when climbing a hill . If you stall or roll backwards, follow the special procedure for braking
described in this manual. Dismount on the uphill side or to a side if pointed straight to uphill. Turn the ATV
around and remount, following the procedure described in this manual,
•Always check for obstacles before operating in a new area. Never attempt to operate over large obstacles, such
as large rocks or fallen trees.Always follow proper procedures when operating over obstacles as described in
this manual.
•Always be careful whe n skidding or sliding .Learn to safely control skidding or sliding by practising at low
speeds and on leve l, smooth terrain . On extremely slippery surfaces, such as, ice, go slowly and be very cautious
in order to avoid out of control when skidding or sliding.
•Never operate an ATV in fast flowing water or in water deeper than that specified in this manual. Remember
that wet brakes can rekuce stopping ability. Test your brakes after leaving water. If necessary, apply them for
several times to let friction linings dry out.
•Always be sure there are no obstacles or people behind you when you operate in reverse. When it is safe to proceed
in reverse, go slowly.
•Always use the tires with proper size and type tires specified in this manual. Always main tain pr oper tire pre ssure
as described in this manual.
•Never modify an ATV through improper installation or accessories,
•Never exceed the stated load capacity for an ATV.Cargo should be distributed properly and attached securely.
Reduce speed and fpllow instructions in this manual for carrying cargo. Allow longer distance for braking.
•The combined weight of the rider,and any accessories or cargo must never exceed the vehicle s load capacity
of 200lbs,
•Do not tow a trailer. This vehicle is not designed for such use.
USER'S MANUAL
4
,