Attaching The Kneepad - Invacare Reliant 440 Owner's Operator And Maintenance Manual

Attaching the Kneepad

The kneepad is an integral part of the lift and MUST be attached so that the lift can
function correctly and safely.
When connecting the actuator to the boom, DO NOT over-tighten the bolt
because this will deform the clevis and restrict the pivot.
NOTE: For this procedure, refer to FIGURE 2.2 on page 13.
1. Connect the top of the actuator to the boom using the bolt provided (Detail "A").
2. Insert the two posts of the kneepad into the tube retainers of the kneepad receiver
while turning the kneepad release lever in a clockwise direction (Detail "B").
3. Release the kneepad release lever.
4. Slide the kneepad in or out until it is locked into position.
DETAIL "A"
Boom
Actuator
Bolt
Part No 1141431
WARNING
CAUTION
Kneepad
Release
Lever
Tube
Retainer
Post
FIGURE 2.2 Attaching the Kneepad
13
SECTION 2—ASSEMBLY
DETAIL "B"
Kneepad
Tube
Receiver
Retainer
Post
Kneepad
Reliant™ 440