Raising/Lowering the Patient Lift
NOTE: For this procedure, refer to FIGURE 3.2.
1. Perform one of the following:
• Raising Lift ‐ Press the Up button on
the hand control to raise the lift arms
and the patient.
• Lowering Lift ‐ Press the Down
button on the hand control to lower
the lift arms and the patient.
NOTE: If the stand‐up lift is in the full Up
position, it may be necessary to pull down slightly
on the lift arms before the mast will lower.
Closing/Opening Leg Base
NOTE: For this procedure, refer to FIGURE 3.3.
The bottom row of the hand control is used
to open or close the legs of the base for
stability prior to lifting a patient. Pressing the
left button widens the leg base; the right
button closes the leg base.
Using the Emergency Stop
NOTE: For this procedure, refer to FIGURE 3.4.
• Press the RED emergency stop button on
the control box to stop the lift arms and
patient from raising or lowering.
• To disengage, rotate the RED emergency
stop button CLOCKWISE until it pops
out.
Part No 1141431
SECTION 3—OPERATION
Up Button
FIGURE 3.2 Raising/Lowering the Patient Lift
Widen Leg
Base
FIGURE 3.3 Closing/Opening Leg Base
Control
RED Emergency Stop Button
Box
Press to Stop
Lift Arms
FIGURE 3.4 Using the Emergency Stop
17
Down Button
Hand Control
Close Leg
Base
Hand
Control
Rotate CLOCKWISE to
Disengage Emergency Stop
Reliant™ 440