Specifications; Assembly; Attaching Mast To Base; Attaching Electric Actuator To Mast - Invacare RPS350-1E Owner's Operating And Maintenance Manual

SPECIFICATIONS/ASSEMBLY

SPECIFICATIONS

S
P
Height at Sling Hook-
up Knob MAXIMUM:
E
C
Height at Sling Hook-
I
up Knob MINIMUM:
F
Base Width OPEN:
I
Base Width CLOSED:
C
Base Height
A
(Clearance):
T
Base Length:
I
O
Overall Height:
Overall Length:
N
Overall Width:
S
Caster Size FRONT:
Caster Size LOCKING
REAR:
Sling Options:
Sling Material:
Weight Capacity:
Weight:
Battery:
Charger Input:
Charger Output:
Charging Time:
Audio Low Battery
Alarm:
Motor Safety Devices:
* Approx. Lifts per
A
Charge:
S
S
Warranty (Electric/
E
Electronics):
M
Emergengcy Stop
B
Button:
L
Y
* Varies dependent upon load and stroke.
PATIENT SLINGS: STANDING
Width
Length
Stand Up Lift
168 cm
102 cm
94 cm
66 cm
12 cm
90 cm
124.5 cm
99 cm
65.5 cm
7.6 cm
12.7 cm
Standing or Transport (See
below for details)
Polyester
159 Kg
52.2 Kg
24 VDC (RECHARGEABLE)
100 - 240 VAC
29.5 VDC
Maximum 6 Hours
YES
Anti-Entrapment
*100-200 Cycles per
Charge
1 Year
YES
TRANSPORT
91.4 cm 97.8 cm
33 cm 91.4 cm

ASSEMBLY

ATTACHING MAST TO BASE

(FIGURE 1)
1. Lock the rear swivel casters. Refer to LOCKING/
UNLOCKING THE REAR SWIVEL CASTERS in
this section of the manual.
2. Remove the hex bolt, nut and washer, that are lo-
cated in the U-shape cut-out of the base.
3. Position the mast in an upright position and place the
mast onto the U-shaped cut-out of the base.
4. Insert hex bolt with washers through the base and
mast. Secure with nut.
WARNING
The mast may be removed from the base
for storage or transporting. Each time mast
is removed and returned to base, the mast
MUST be properly secured to the base.
Mast
Hex Bolt
FIGURE 1 - ATTACHING MAST TO BASE
ATTACHING ELECTRIC ACTUATOR
TO MAST (FIGURE 2)
1. Remove the top nut, top bolt, bracket and bushing
from the lift arm mounting bracket.
2. Position the electric actuator in the lift arm mounting
bracket as shown in FIGURE 2.
3. Reinstall top nut, top bolt, bracket and bushing into lift
arm mounting bracket and electric actuator. Tighten se-
curely.
CAUTION
DO NOT overtighten mounting hardware.
This will damage mounting brackets.
6
Washer
Nut
U-Shaped
Cut-out