Keurig K-CUPK70 Owner's Manual page 7

P7 201309003 KER755_K70-75.pdf 1C( K) ZB2319 2013.09.06
small amounts of water coming from the Vent
4
fig.
and dripping into the Water Reservoir during
this and subsequent heating — this is normal.
Lift and lower the Handle. Press the flashing
9.
BREW Button to start a cleansing brew
without a K-Cup pack. When the brew cycle
®
is complete, pour the hot water into the sink.
NOTE: A K-Cup pack should not be used for
®
.
this sequence
The one-time set-up process is now
10.
complete and you are ready to brew!
NOTE: The brewer may take 15-30 seconds
between brews and then "READY TO BREW"
will be indicated.
5
fig.
ready to Brew Your First cup
LCD Control Center will indicate
1.
"READY TO BREW."
Place a cup or mug on the Drip Tray Plate.
2.
Lift the Handle and the K-Cup
3.
Holder will open toward you (fig. 5).
Select a K-Cup pack.
4. ®
NOTE: Do not remove the foil
lid or puncture the K-Cup
Pack
®
pack.
®
7
Place a K-Cup pack in the K-Cup
5. ®
Holder (fig. 6).
CAUTION: There are two sharp
needles that puncture the K-Cup
above the K-Cup Pack Holder and the other in
®
6
fig.
the bottom of the K-Cup Pack Holder. To avoid
®
risk of injury, do not put your fingers in the
K-Cup Pack Assembly Housing.
®
Lower the Handle to close the Lid over the
6.
K-Cup Pack Holder. (When it is closed
®
completely, the LCD Control Center will
indicate "READY TO BREW." The Left and
Right Buttons will be lit and the BREW Button
will flash up to 60 seconds.)
All brew size icons are lit with the default
a.
size flashing (fig. 7). To choose a different size,
press Left Button to go down in size or Right
7
fig.
Button to go up in size.
NOTE: The Small Mug is
the factory set default brew size. To program
your favorite brew size see page 13
"Programming Your Brew Size."
Your choices are a stronger Extra-Small
b.
Cup (3.25 oz. serving), a Small Cup (5.25 oz.
serving), a Small Mug (7.25 oz. serving), a
Large Mug (9.25 oz. serving) or a Travel Mug
(11.25 oz. serving).
Pack
®
pack, one
®