Fusion MS-IP700i User Manual page 11

SETTING UP VHF
Note: A marine FM antenna is required for VHF reception, DO NOT connect to a VHF
splitter.
Minimizing background noise
Use the Squelch feature to reduce background noise on VHF input. Select a VHF
channel, and then adjust the squelch control while there is nothing being transmitted
on the channel.
To set the squelch level:
1. Press the Menu key.
2. Turn and then press the Encoder to select Squelch.
3. Turn the Encoder to adjust the squelch level:
• Increase the squelch level until the background noise is muted.
• Reduce the squelch level if the audio transmission is not heard.
4. Press any key to exit
Turning scan mode on
Scan mode allows the 700 Series to scan through preset VHF channels,
looking for active channels.
Note: If the Squelch level is adjusted so that you can hear a constant hissing
sound, the unit will not scan correctly. To correct this, see "Minimizing back-
ground noise", above.
To turn scan mode on:
1. Press the Menu key.
2. Turn the Encoder to highlight the Scan menu item.
3. Press the Encoder to select the checkbox ( ). Scan mode is turned on and the
menu exits automatically.
Note: Pressing the Play / Pause, Forward or Rewind key turns scan mode off.
19
iPod
PLAYING CONTENT
Before you can use your iPod as an input source you must first connect the device
to the 700 Series. For further details, see "Preparing for iPod or USB Input" on page
43.
To listen to input from your iPod:
MS-IP700i
• Press the iPod key. The iPod input source screen is dis-
played. The most recently selected track starts playing at
the current play point.
• To appear on the iPod source screen the iPod may either
iPod
be inserted into the internal dock or connected to the
external USB connector.
MS-AV700i • Press the Auxiliary key. Keep pressing the key until the
iPod source screen is displayed.
Auxiliary
iPod SOURCE SCREEN
An example of a typical iPod input source screen is shown in Figure 4 below.
Figure 4 – Example iPod input source screen
20