Chapter 4 Connecting The Switch - Planet FSD-803PE User Manual

TThis chapter describes how to connect the Switch to your Fast Ethernet network.
PC to Switch
A PC can be connected to the Switch via a two-pair Category 3, 4, 5 UTP/STP straight
cable. The PC (equipped with a RJ-45 10/100Mbps phone jack) should be connected to
any of the 8 numbered port.
The LED indicators for PC connection depend on the LAN card capabilities. If LED
indicators are not light after making a proper connection, check the PC LAN card, the
cable, the Switch conditions and connections.
The following are LED indicator possibilities for a PC to Switch connection:
• The LINK/ACT and 100 LED indicators light green for hookup to 100Mbs.
• LNK/ACT lights green, while 100 LED off for hookup to 10Mbps speed.
Hub to Switch
A hub (10 or 100Base-TX) can be connected to the Switch via a two-pair Category 3, 4, 5
UTP/STP straight or crossover cable. The connection is accomplished from the hub Uplink
(MDI-X) or normal (MDI) port to any of the Switch (MDI/MDI-X) ports:
A. 10Base-T Hub
For a 10Base-T hub, the Switch LED indicators should light up as the following:
100 LED indicator is OFF.
LNK/ACT LED indicator lights green.
B. 100Base-TX Hub
For a 100Base-TX hub, the Switch LED indicators should light up as the follow-
ing:
LNK/ACT,100 LED indicators light green.
10-000039-000.indd 11
CONNECTING THE SWITCH
2004/8/27,
Chapter 4
11
05:37