Re-Installing The Automatic Sheet Feeder - Star LC-90 User Manual

Table of Contents

Advertisement

14
Printer Setup

Re-installing the automatic sheet feeder

Open the front cover of the printer.
Carefully lower the automatic sheet feeder into the printer, making sure that
the two round tabs on either end of it enter into the corresponding slots
inside the printer. You should have the automatic sheet feeder angled
towards the front of the printer (at about the same angle that it was when
you pulled the feeder forward while detaching it).
You should have the automatic sheet feeder angled towards the front of the
printer (at about the same angle that it was when you pulled the feeder
forward while detaching it).
Lower the automatic feeder all the way down. When you do, it should
naturally slip into place, with the part that holds the paper angled slightly
towards the back of the printer.
Close the front cover of the printer.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nx-1010

Table of Contents